CPC中文印刷社区 - Kodak T Series Plate Processors Service Manual.

-= Kodak Confidental =-

Kodak T Series Plate Processors Service Manual.

Contents:

1- Safety
Who Should Use This Guide
For More Information
Danger, Warning, Caution, and Notice Paragraphs
Important Notes about Safe Operation
Safety Features
Interlock Switch
Emergency Stop Buttons
Safety Guidelines

2- Installation
Preparing to Install the Processor
Site Inspection
Installation Procedure
Tools and Equipment
Unloading the Processor
Inspecting the Crate
Positioning and Unpacking the Processor Crate
Leveling the Processor
Positioning the Drip Trays
Removing and Mounting the Side Panel
Transferring the Touch Screen Display
Connecting the Power Supply
Selecting Wash Water and Drainage Options
Connecting the Water Supply
Configuring the Recirculation Valves
Connecting the Drainage System
Connecting Other Supply and Drainage Hoses
Developer Fill Hose
Developer Replenisher Hose
Developer Drain Hose
Gum Supply and Drain Hoses
Preparing the Chiller
Installing the Stacker
Installing the Input and Output Tables
Input Table
Output Table
Installing the Filters
Turning On the Processor
Adjusting the Touch Screen Contrast
Checking the Model Number and Configuration
Filling the Processor With Developer
Filling the Processor With Water
Adjusting the Gum Flow
Setting the Roller Pressure
Configuring the Processor Settings
Cleaning the Processor and Installation Site
Training Processor Operators

3- Adjustments and Settings
Introduction
Accessing Menu Options
Accessing Service-Specific Settings
Adjusting the Starting and Stopping Points for Mechanical Operations
Understanding Offsets
Calibrating and Setting the Chiller Temperature Sensor
Calculating the Offset for the Chiller Temperature Sensor
Setting the Chiller Temperature
Configuring Idle Cycles
Calibrating the Developer Temperature Sensor
Configuring Permitted Deviations in the Developer’s Temperature
Calibrating the Dryer Temperature
Calibrating the Conductivity Sensor
Adjusting the Dip Time
Setting the Speed for Clearing Plate Jams
Setting the Gum Rinse Duration
Viewing the Processor’s Error Log
Backing Up and Restoring Data
Locating the Offset Values That Were Set at the Factory

4- Maintenance
Introduction
Replacing Gears

5- Upgrades
In-System Programming (ISP)
Performing the ISP Procedure
Parameters and Settings
Settings for Program 1
Settings for Program 2
Settings for Program 3