施乐风神4112开机出代061-320，请问是哪的问题啊
 

施乐风神4112开机出代061-320，请问是哪的问题啊

应该是激光器挂了吧。多边电机的事。

061-320 Polygon Motor Fail
BSD on:CH6.11
Description
The qty of Polygon Motor rotations did not become normal 4sec after Polygon Motor ON.

Procedure
Enter the UI diag.

Enter DC330[061-200](Polygon Motor Ready). Select Start.

Press the Enter Number button. Enter [061-001](Polygon Motor ON/OFF). Select Start.

Four sec. after the Polygon Motor turned ON, enter [061-200](Polygon Motor Ready). Press the Show Current Status button to see what is displayed.

With the Polygon Motor ON, the display is Low.
Yes No

Replace the ROS Assy (PL 6.1).

Seeing BSD CH1.12, check the Front Door Interlock Switch circuit for such a poor connection as causes its chattering.

激光多棱镜马达没转，风神机器前门开关控制激光5V电压，可能是马达5V电不足，检查检查前门开关吧！！

谢谢，可能是前面开头吧，没弄他，只是把前面用力关了几下，再开机没出问题了

门开关最好有问题就早换...免得把激光整坏了....