施乐C800报077-134
 

施乐C800报077-134，求助！！！！！！！！！

C800应该是全新全包机器吧，我玩二手的还没见过真机呢

唉，一声叹息，飘过~:secret_smile:

077-134 Lead Regi Error
Detection Condition
During the Registration operation, the Regi Out Sensor did not turn ON within the specified time after the Regi Sync signal is ON.

Note
When the NVM DC131 [742-505] is "0", this Fail is a hidden failure. When the NVM is "1", it is a Jam (Dynamic) failure.

Warning
Before doing any procedure other than such checks as diagnostic ones that are made with the machine alive, be sure to turn OFF the machine.

Electrical Parts to Check
The table shows the electrical parts related to this Fault Code for display. Utilize information on the table below for making a decision as to whether an electric part is good or not. After making a decision, replace the part as required.

When checking electrical parts, check connectors as well.

To decide whether individual parts such as sensors and motors are defective, go to 2.2.4 Generic FIPs.

没碰过机器的人按照这样弄，机器就真的会坏的！:bad_egg:

77-134 定位轮压力过大 纸张属性里面减少压力试一下-----30左右

还不行试着换下斜轮


77-135 是压力过小 需要加大压力


还有定位辊那里要看一下


还有一种情况 近期遇到的


如果反复卡134 而且卡的都是文件的同一个位置 那就是文件问题 把这一页转图片就可以解决问题

77-134代码出现频繁的主要原因：对位辊阻力过大、斜轮阻力过大、3号位传感器脏、二转印辊磨损、二转印辊驱动齿轮磨损