wasatch softrip 7.1 打印尺寸少两厘米
 

打印图的尾巴会自动少掉两厘米没打，用蒙泰都不会，图没问题，请教大家怎么解决。

I don't think Wasatch has it, but you have to perform a length compensation. Usually you print about four feet ruler and measure it, then enter the measurement into the Rip and it will adjust the job by applying the difference over the entire length of the Job.

So, if the job was .5 inch too short it would spread the .5 or the whole job by increasing the overall length, on half inch.

你试试改为品质模式~~~~~~~~

有可能是wasatch驱动的问题，导致RIP生成的数据不完整。