我自己认为，在稳定性、显影的宽容度方面，富士版绝对是一流的
用过的人应该都有相同感觉
在V速度(29张/小时)的全胜机器9W的曝光功率，300转，柯达也未必能及
但价格就不好说了，比国产肯定要贵些，比其它进口的可能要便宜些
以下是我们公司使用的参数(四年前的，现在改国产版了)
>> set hdm 1
NVS hdm (Head Media Parameters) calibration [1]: (NVS checksum PASS)
Head data loaded, active values match head saved values
Head & MPE
Set name Full name Active Saved Default Units
-------------------------------------------------------------------------
name media_type_name "Fuji" "Fuji"
colour proofer_colour "" ""
bmcurve beam_curvature 1 1 0 %
bmslope beam_slope 2 2 0 %
fmode focus_mode 4 4 0
sv surface_velocity 2.770 2.770 2.770 m/sec
svn surface_velocity_nrw 2.770 2.770 2.770 m/sec
ds drum_speed 300.000 300.000 150.000 rpm
wpower wr_laser_power 9.000 9.000 10.000 watts
bmcurven beam_curvature_nrw 1 1 0 %
bmslopen beam_slope_nrw 1 1 0 %
dsn drum_speed_nrw 300.000 300.000 150.000 rpm
wpowern wr_laser_power_nrw 9.000 9.000 10.000 watts
sens nominal_sensitivity 170.000 170.000 170.000 mJ/cm^2
sensadj sensitivity_adjust 0 0 0 %
wpowere wr_laser_power_exp 10.000 10.000 10.000 watts
wpowers wr_laser_power_std 0.000 0.000 0.000 watts
sr surface_reflectivity 0.120 0.120 0.100
sd surface_depth -2 -2 0 microns
plots total_plots 237 237 0
fplots failed_plots 8 8 0
retrace total_retraces 391 391 0
edges total_edge_detects 23 23 0
fedges failed_edge_detects 2 2 0
fheadcal focus_head_cal 9.000 9.000 5.000