引用:
作者: 永念快印
012-159.不分页就没有这个代码。
|
012-159 Eject Sensor ON Jam
BSD on:CH12.39 CH13.40
Description
Punch Mode OFF:
Eject Sensor does not turn ON a spec time after Compile Exit Sensor ON.
In Punch Mode:
Regarding large paper, Compile Exit Sensor does not turn ON a spec time after the start of punching.
DC330 Code to Check
[012-138] Eject Sensor
[012-034] Eject Motor
[012-106] Compile Exit Sensor
[012-019] Compile Exit Motor
[013-040/041] Eject Clamp Motor
Check Items
Paper Path for a foreign object/a burr/a piece of paper
Compile Exit Roll for dirt/paper particles/wear/a poor rotation
Check for an improper Nip operation.
Eject Roll for dirt/paper particles/wear/a poor rotation
Sensor Actuator for an improper operation
Check for out-of-spec paper.
Check the following for an open wire, short or poor contact. If the wires are good, replace the Eject Sensor (PL 17.24).
Eject Sensor J8039-2 to Finisher PWB J8013-7
Eject Sensor J8039-1 to Finisher PWB J8013-8
Eject Sensor J8039-3 to Finisher PWB J8013-6
If the results of the above checks are OK, replace Finisher PWB (PL 17.3).