077-134 Lead Regi Error
Detection Condition
During the Registration operation, the Regi Out Sensor did not turn ON within the specified time after the Regi Sync signal is ON.
Note
When the NVM DC131 [742-505] is "0", this Fail is a hidden failure. When the NVM is "1", it is a Jam (Dynamic) failure.
Warning
Before doing any procedure other than such checks as diagnostic ones that are made with the machine alive, be sure to turn OFF the machine.
Electrical Parts to Check
The table shows the electrical parts related to this Fault Code for display. Utilize information on the table below for making a decision as to whether an electric part is good or not. After making a decision, replace the part as required.
When checking electrical parts, check connectors as well.
To decide whether individual parts such as sensors and motors are defective, go to 2.2.4 Generic FIPs.