[balenofeng]

作者: lxflang521

是的 重启也这样 把下边整个组件拉出来开机也是报代码。

8-310 Hiper Regi Disconnect Fault RAP
Description
Hiper Regi Disconnect Fault.

Initial Action
Refer to BSD 1.3 and BSD 8.16 for the following procedure.

Procedure
CR5 (Green LED) on the Hiper Regi PWB is On.
Yes No Unanswered

Check Fuse (F2) on the Distribution 1 PWB ( PL 13.3).

Fuse (F2) is good.
Yes No Unanswered

Replace Fuse (F2) ( PL 13.3).

Go to Flag 3 and Flag 4 on BSD 8.16 and check the harness and connectors for an open circuit.

The harness and connectors are good.
Yes No Unanswered

Repair the harness and connectors.

Replace the Hiper Regi PWB ( PL 13.3).

CR1 (Green LED) on the Hiper Regi PWB is On.
Yes No Unanswered

Verify that ROM (U2) is installed correctly.

ROM (U2) on the Hiper Regi PWB is installed correctly.
Yes No Unanswered

Perform the following:

Correctly install the ROM (U2).

Replace the Hiper Regi PWB ( PL 13.3).

Replace the Hiper Regi PWB ( PL 13.3).

Go to Flag 1, Flag 2 and Flag 3 on BSD 8.16 and Flag 30 on BSD 1.3. check the harness and connectors for an open circuit.

The harness and connectors are good.
Yes No Unanswered

Repair the harness and connectors.

Go to Flag 4 and Flag 5 on BSD 8.16 and check the harness and connectors for an open circuit.

The harness and connectors are good.
Yes No Unanswered

Repair the harness and connectors.

Perform the following:

Replace the Hiper Regi PWB ( PL 13.3).

Replace the IOT PWB ( PL 13.3).

Go to the OF2 Intermittent Fault RAP.