012-102 Punch Out Sensor ON Jam
BSD on:CH12.27 CH13.27
Description
Punch Out Sensor does not turn ON a spec time after Decurler Out Sensor ON or Folder Exit Sensor ON.
DC330 Code to Check
[012-101] Decurler Out Sensor
[013-141] Folder Exit Sensor(With Folder)
[012-105] Punch Out Sensor
[012-001] Decurler Transport Motor
[013-028] Folder Entrance Motor(With Folder)
Check Items
Folder Exit Roll for dirt/ wear/a poor rotation (with Folder)
Finisher Entrance Roll for dirt/paper particles/wear/a poor rotation
Paper Path for a foreign object/a burr/a piece of paper
Check for out-of-spec paper.
Check the following for an open wire, short or poor contact. If the wires are good, replace the Punch Out Sensor (PL 17.17).
Punch Out Sensor J8083-2 to Finisher PWB J8022-14
Punch Out Sensor J8083-1 to Finisher PWB J8022-15
Punch Out Sensor J8083-3 to Finisher PWB J8022-13
If the results of the above checks are OK, replace Finisher PWB (PL 17.3).
012-151 Compile Exit Sensor OFF Jam
BSD on:CH12.32 CH13.32
Description
Compile Exit Sensor does not turn OFF a spec time after Compile Exit Sensor ON.
DC330 Code to Check
[012-019] Compile Exit Motor
[012-106] Compile Exit Sensor
Check Items
Compile Exit Roll for dirt/paper particles/wear/a poor rotation
Main Paddle for a poor rotation
Eject Roll for dirt/paper particles/wear/a poor rotation
Check if a proper Nip operation is performed for paper ejection.
Paper Path for a foreign object/a burr/a piece of paper
Check for out-of-spec paper.
Check the following for an open wire or poor contact. If the wires are good, replace the Compile Exit Sensor (PL 17.2).
Compile Exit Sensor J8054-2 to Finisher PWB J8014-29
Compile Exit Sensor J8054-1 to Finisher PWB J8014-30
Compile Exit Sensor J8054-3 to Finisher PWB J8014-28
If the results of the above checks are OK, replace Finisher PWB (PL 17.3).