引用:
作者: Bloodsaler
 想问问xxyyzz97老大，是串墨辊正向转一周，印版滚筒即转了两圈是吧？从你字里行间我是这样理解的。
至于调整串墨辊的位置来适应活件需要，安排油墨碾平最好的区域对应活件相应区域，我想问问串墨辊所调整的是哪个方向？哪位老大能详细讲讲这种调整是怎样调整么？
而且对应的印版上的区域有没有特定位置的要求？需要对应于印版中心还是说不同位置通过调整串墨辊都可以对相应位置有很好的油墨碾平？ |
I mean that the oscillator from the very left side travel across to right side, the plate cylinder would turn on turn. Then the oscillator return from right to left then the cylinder would turn another turn. So for a round travel of oscillation, the cylinder will turn 2 times.
Originally I have a layout to show the describe the ink evenness distribution, but I cannot find it. The starting point of the oscillation, for example, in normal setting, the starting motion of the oscillator should at the nip area, because at this position, there is enough printed. Now the most important part of the job is very close to the gripper, in order to get the most even film at this part, then we need to adjust the starting position of oscillation, at this moment which will not start at the nip area.
The modern press using the drive motor installed at the oscillator assy. Operator can change the position from the console.
I believed that your KBA C215 should have this feature.
You can adjust the starting position of oscillator at at place, there is no limitation or only set at a few places.