[hbqclq]

施乐700报045-360。出045-360后重启机器，可以复印，打印一两张又报045-360，复印没有问题，求解

[hbqclq]

有说是激光器排线没插好，插了N次，快把排线插废了还是不行，报激光器换了，排线换了不行

[caoyongquan]

作者: hbqclq

有说是激光器排线没插好，插了N次，快把排线插废了还是不行，报激光器换了，排线换了不行

是转印感应器问题，你实施看看是转印感应器问题，你实施看看是转印感应器问题，你实施看看是转印感应器问题，你实施看看是转印感应器问题，你实施看看是转印感应器问题，你实施看看是转印感应器问题，你实施看看

[dcj277185974]

应该是服务器，要重做系统了。前段时间我的也是这样，频繁报这个代码，偶尔能打一、两张，后来海贼给我重发了硬盘，这段时间一直没出这个代码了。

[balenofeng]

不知道楼主能否看懂？

045-360 Cont IF Error Y Fail
Bsd-on:CH6.9

The MCU PWB detected an error with the image sync signal from the External ESS (DFE) to the IOT. (Y)

The detection function works only during a print job from the External ESS (DFE), so turning OFF then ON the IOT will clear this Fail. However, if a print job is run again from the External ESS (DFE), this fault may sometimes reoccur. The image sync signal is routed from External ESS (DFE) to VSEL PWB to BP PWB to MCU PWB.

Procedure
Check if the cable is properly connected between the External ESS (DFE) and the VSEL PWB. If it is good, replace the following parts in order:

Cable between External ESS (DFE) and VSEL PWB

I/F PWB on the part of External ESS (DFE)

VSEL PWB (PL 35.2)