[亿彩佳印]

6.1.4.3 E0200A/ E0200B/ E0200C/ E0200E/ E0200F/ E02010/ E02017/E02018/ Registration sensor error
<Cause> This is displayed when the light intensity of the registration sensor could not be adjusted during media loading.This is displayed when the registration sensor has detected a media loading position error during detection of the media right edge.This is displayed when the registration sensor could not detect the media leading edge during detection of the media leading edge.This is displayed when the registration sensor has detected a media smaller than the prescribed size during media loading.This is displayed when the registration sensor has detected a media larger than the prescribed size during media loading.This is displayed when the registration sensor detects slanting that exceeds the prescribed amount during media loading.This is displayed when the registration sensor could not detect the media right edge during media loading.This is displayed when the registration sensor could not detect the media left edge during media loading.
<Probable problem locations>Media, media loading procedure, paper path, registration sensor, carriage relay PCB, engine controller and system controller
<Remedy>1. Media check Replace any media that have printing or soiling at the detection position or that are outside the prescribed size.2. Media loading checkReload the media if there is anything abnormal about the media loading status.3. Visual check Remove any foreign objects adhering to the registration sensor.4. Registration sensorUse SERVICE MODE> DISPLAY> SYSTEM> SIZE CR to check the reading of the registration sensor. Replace if it is not functioning normally.5. Cable connection check Replace the cable between the registration sensor and carriage relay PCB if the connection is not functioning normally.6. Replace the carriage relay PCB.7. Cable connection check Replace the cable between the carriage relay PCB and engine controller if the connection is not functioning normally.8. Replace the engine controller.9. Replace the system controller.