[balenofeng]

作者: cuiwy0603

今天换了显影的档粉片，重新开机后报092-311，
我还没有搞明白092-311是哪里的错误，
有知道解决方法的吗？
哎，搞了一整天，饭都没吃。

092-311 ADC Toner Image Fail
Bsd-on:CH9.8

The condition causing ADC Patch Fail has occurred continuously.

Causes:

The density of the image on the Drum surface is very light. E.g.: Cin 100%<1.0

IOT (charge to development) failure

Low TC

ADC Sensor sensitivity error due to improper installation

ADC Patch was scraped off from Transfer Belt, etc.

Procedure
Check in the given order.

Turn On DC330[093-001]Deve Motor and check if the Deve Unit rotates normally. If it doesn't, go to 093-320 Deve Motor Fail FIP.

Turn On DC330[093-003]Dispense Motor and check if the Dispense Motor rotates normally. If it doesn't, go to 093-311 Dispense Broken FIP.

Check how the ADC Sensor bracket is seated. (REP 11.1.4)

Perform DC935 Procon On Print and check if the Transfer Belt contacts/retracts.

If the problem is not resolved, it indicates that the Drum Unit (PL 11.1), HVPS S5 (Deve Bias) (PL 2.3) and/or ROS (PL 6.1) are/is defective.