[单车男孩婵]

012-102 Punch Out Sensor ON Jam
BSD on:CH12.27 CH13.27
Description
Punch Out Sensor does not turn ON a spec time after Decurler Out Sensor ON or Folder Exit Sensor ON.

DC330 Code to Check
[012-101] Decurler Out Sensor

[013-141] Folder Exit Sensor(With Folder)

[012-105] Punch Out Sensor

[012-001] Decurler Transport Motor

[013-028] Folder Entrance Motor(With Folder)

Check Items
Folder Exit Roll for dirt/ wear/a poor rotation (with Folder)

Finisher Entrance Roll for dirt/paper particles/wear/a poor rotation

Paper Path for a foreign object/a burr/a piece of paper

Check for out-of-spec paper.

Check the following for an open wire, short or poor contact. If the wires are good, replace the Punch Out Sensor (PL 17.17).

Punch Out Sensor J8083-2 to Finisher PWB J8022-14

Punch Out Sensor J8083-1 to Finisher PWB J8022-15

Punch Out Sensor J8083-3 to Finisher PWB J8022-13

If the results of the above checks are OK, replace Finisher PWB (PL 17.3).



012-151 Compile Exit Sensor OFF Jam
BSD on:CH12.32 CH13.32
Description
Compile Exit Sensor does not turn OFF a spec time after Compile Exit Sensor ON.

DC330 Code to Check
[012-019] Compile Exit Motor

[012-106] Compile Exit Sensor

Check Items
Compile Exit Roll for dirt/paper particles/wear/a poor rotation

Main Paddle for a poor rotation

Eject Roll for dirt/paper particles/wear/a poor rotation

Check if a proper Nip operation is performed for paper ejection.

Paper Path for a foreign object/a burr/a piece of paper

Check for out-of-spec paper.

Check the following for an open wire or poor contact. If the wires are good, replace the Compile Exit Sensor (PL 17.2).

Compile Exit Sensor J8054-2 to Finisher PWB J8014-29

Compile Exit Sensor J8054-1 to Finisher PWB J8014-30

Compile Exit Sensor J8054-3 to Finisher PWB J8014-28

If the results of the above checks are OK, replace Finisher PWB (PL 17.3).